Smart Battery Charger Precautions

Smart Battery Charger Precautions

First: Inspect and eliminate battery faults promptly and regularly until the appearance is not acidic. Every month, wipe the surface thoroughly with distilled water and wipe with a dry cloth or anti-static cloth to keep the charger clean;

Second: The intelligent battery charger completely removes the oxides and rust of metal parts (such as terminal blocks). Every half month should carefully check the contact conditions and firmness of the battery charger connection bars, poles, and output connections. Replace petroleum jelly in metal parts.

Special attention: Do not use chemical or abrasive cleaners to avoid damage to the cabinet;

Third: Smart Battery Charger prohibits the addition of sulfuric acid! The electrolyte density was checked and adjusted in time. When the electrolyte level is low, distilled water should be added to the normal level in time;

Fourth: In order to avoid inaccurate instruments, check and verify the meter used for battery measurement. Causes the quality of the battery maintenance work to be affected;

According to the requirements of the instructions, adjust the electrolyte density according to the changes of the climate season.

Fifth: Smart battery charger Please carefully review the instructions, but also pay special attention to the battery charger precautions, and give the appropriate environment, such as:

A. It is necessary to prevent the charger from being exposed to strong vibrations or exposed to temperature and humidity. The charger is limited to indoor use. Beware of rain.

B. In the absence of people or long-term unused conditions, it is necessary to disconnect the AC power;

C. The charger should be rotated vertically in a dry and ventilated environment to avoid moisture and to inflammable and explosive products.

D. Do not cover the charger during charging. Use ambient temperature no more than 40 degrees.

E. It is prohibited to charge non-rechargeable batteries;

F. The interval between two booting is not less than 10 seconds (cut off the input power);

G. Charger shall not disassemble without authorization;

H. Disconnect the charger from the battery when the battery is full.

respected user:

Thank you for your attention to our products. In addition to this product introduction, our company also has vacuum degree tester, infrared thermometer, dielectric loss tester, high voltage test transformer, vacuum oil filter, high current generator, etc. If you are interested in our products, welcome to inquire. Thank you!