Main contents of minor repair: inspection and repair adjustment device, adjustment of drainage gap; replacement of worn liner and thrust plate; repair and replacement of transmission parts; cleaning of individual parts of crusher ; replacement of lubricating oil repair and adjustment of lubrication system, etc. . Usually half a month or once a month, according to the specific circumstances.
The main content of the repair: including all the work of minor repairs. Replace worn bushings, tie rods, linings, thrust plates; inspect, turn, grind and cast eccentric shaft bushings, connecting rod bushings and moving bushings. The interval between two repairs depends on the wear of the main bearing bush, the connecting rod bearing bush and the moving bush, usually once a year.
The main content of the overhaul: including all the work of the middle repair. Turning the eccentric shaft and the replacement of the movable jaw and the mandrel; Pap alloy casting rod head portion; and replacement of worn parts and the restoration of full member; whole crusher and correcting equipment technological innovation. The interval between two overhauls depends mainly on the wear of the eccentric shaft and the moving mandrel, usually about four years.
Currently a lot of repair crusher beneficiation plant, most methods employed to replace the entire component, i.e. component Preparatory method. When repairing, just remove the worn parts and replace them with new ones, which can greatly shorten the machine parking time and increase the equipment operation rate.
Stainlee Steel Shot is one of the most commonly used Metal Abrasive for shot blasting. And in them, 304 Stainless Steel Shot is also a very high quality one. On the one hand, it could strengthen the surface of die casting parts to make them have the ability of rust resistance. On the other hand, it could make die casting parts have a matte furface. It is widely used in foundry.
Longlived 304 Stainless Steel Shot is made from high quality 304 stainless steel wire by drawing, cutting and rounds.
Chemical Composition (%)
|
C |
Si |
Mn |
P |
S |
Ni |
Cr |
N |
|
0.068 |
0.076 |
1.2 |
0.032 |
0.001 |
8.06 |
18.16 |
0.01 |
Shape: as cut, G1, G2, G3 and even G4.
304 Stainless Steel Shot,,Cast 304 Stainless Steel Shot,304 Stainless Steel Shot As Cut
Longlived Metal Products Co ., Ltd , https://www.tzlonglivedmetal.com