(1) The semi-reverse flow type bottom blown water pipe is sometimes blocked due to calcium formation, causing ore deposits at the nozzle or blockage of the working gap: if there is such a problem, stop the inspection. Sometimes the blown water pipe is not blocked, but there is some debris in the working gap to make the work gap blocked. The fault phenomenon is that there is no concentrate in the barrel, and the magnetic separator can be inserted into the mine by the pressure water hose at this time. The blockage is washed away;
(2) off magnet cylinder: a cylindrical case of a noise lol, severe skin cut the tube, this time should be immediately shut down for maintenance, to prevent the magnetic blocks off again, a thin copper sheet to be used in the maintenance of the magnetic system Hold
(3) Entering obstacles in the magnetic separator: Lighter will mark the barrel and the heavy one will catch the cylinder or cut the barrel. When this phenomenon occurs, stop immediately to remove the obstacle. It should be prohibited usual bolts, nuts, wire and other metal items fall into the magnetic separator, with the pulp in order to prevent lump ores into the magnetic separator, should block the bulk of the ore and debris in the plus sieve, and always clean ;
(4) Grinding holes in the tank body: If the middle layer of the semi-reverse flow tank or the tailings tube is worn out, the ore will short-circuit into the tailings to raise the grade of the tailings. If the tailings grade suddenly rises and remains high, it can be suspected that the tank is leaking;
The use of wet permanent magnetic cylinder magnetic separator should be standardized:
1. The wet permanent magnet magnetic separator should have full-time personnel to inspect and install the operation;
2. The equipment is installed on a horizontal concrete foundation and fixed with anchor bolts;
3. When installing, pay attention to the vertical direction of the main body and the horizontal;
4. Configure the power cord and control switch according to the power of the device;
5. After the inspection is completed, the empty load test is carried out, and the test can be carried out normally;
The inflatable arm floats refers to the two inflatable air circles on the arm, but because the volume of the floating sleeves is small and the pressure it bear is relatively large, the buoyancy is relatively small, so it is only suitable for children. Moreover, when using floating sleeves to learn backstroke, the opponent will have a great impact.
Both inflatable arm floats are available and children can be used, and they can also customize colors, patterns and shapes. The inflatable Pool Floats of P&D are all high-quality PVC, which will not leak air or explode, and can better ensure the safety of users.
pool arm floaties, inflatable arm rings, blow up arm floaties, arm inflatable floaties, blowing up swimming armbands
Lixin Outdoor Product Co., Ltd , https://www.jmpoolfloat.com